Removal and Installation

Remove the LH quarter trim panel access cover.

Fig 1: Removing LH Quarter Trim Panel Access Cover
Courtesy of FORD MOTOR CO.
Unclip the power liftgate rod from the motor assembly.
- Squeeze the clip as shown to release and position the rod assembly upward.
Fig 2: Uncliping Power Liftgate Rod From Motor Assembly
Courtesy of FORD MOTOR CO.
Remove the cover and the power liftgate rod-to-liftgate retaining nut.
- To install, apply threadlock to the threads of the fastener and tighten to 11 Nm (97 lb-in).
Remove the 3 power liftgate rod mounting bracket nuts.
- To install, tighten to 30 Nm (22 lb-ft).
To install, reverse the removal procedure.

Initialize the power liftgate. For additional information, refer to POWER LIFTGATE INITIALIZATION .