LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Panel System - Body Closures >> Removal And Installation >> Pinch Strip Switch >> Removal and Installation

Removal and Installation

  1. Remove the liftgate trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the pinch strip electrical connector.
    Fig 1: Locating Pinch Strip Electrical Connector
    G06070787Courtesy of FORD MOTOR CO.
  3. Remove the pinch strip.
    • Remove the pin-type retainers.
    • Remove the grommet and route the harness out of the vehicle.
    Fig 2: Locating Pin-Type Retainers
    G06070788Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals