Removal and Installation

Remove the LH rear quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Disconnect the Liftgate/Trunk Module (LTM) electrical connectors.

Fig 1: Locating Liftgate/Trunk Module (LTM) Electrical Connectors
Courtesy of FORD MOTOR CO.
Remove the LTM retaining bolts and remove the LTM .
- To install, tighten to 9 Nm (80 lb-in).
Fig 2: Locating LTM Retaining Bolts
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Initialize the power liftgate. For additional information, refer to POWER LIFTGATE INITIALIZATION .