LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Handles, Locks, Latches & Entry Systems >> General Procedures >> Ignition Lock Cylinder - Non Functional >> Removal

Ignition Lock Cylinder - Non Functional: Removal

  1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  2. Remove the ignition lock cylinder.
    1. Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
    2. Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition lock cylinder breaks loose.
    3. Remove and discard the ignition lock cylinder and drill shavings from the steering column.
  3. Remove the bearing retainer.
  4. Remove the steering column lock housing bearing and steering column lock gear.
  5. Thoroughly clean all drill shavings from the steering column and inspect it for damage.
scientia non olet · About LEMON Manuals