Removal and Installation

Remove the cowl panel grille. For additional information, refer to FRONT END BODY PANELS .
Remove the wiper mounting arm and wiper pivot shaft assembly in the following sequence.
1. Remove the 3 bolts.
  - To install, tighten to 18 Nm (159 lb-in).
2. Disconnect the electrical connector.
3. Detach the wire harness pin-type retainer.
Fig 1: Locating Wire Harness Pin-Type Retainer
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Adjust the wiper pivot arms. For additional information, refer to WIPER BLADE AND PIVOT ARM ADJUSTMENT - WINDSHIELD .