LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Removal And Installation >> Washer Pump >> Removal and Installation

Removal and Installation

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
  3. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
    NOTE: When installing a new washer pump, be careful not to damage the rubber grommet.
    NOTE: To prevent spilling washer fluid, drain the washer reservoir before washer pump removal.

    Remove the washer pump.

    • Disconnect the electrical connector.
    • Disconnect the hoses.
    • Remove the windshield washer pump.
  4. NOTE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature pump failure.

    To install, reverse the removal procedure.

    • Fill the washer reservoir with windshield washer fluid.
scientia non olet · About LEMON Manuals