Removal and Installation

Remove the washer reservoir cap from the washer reservoir.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the RH front fender splash shield. For additional information, refer to FRONT END BODY PANELS .
Remove the 2 RH reinforcement bracket-to-fender bolts and the 2 RH reinforcement bracket-to-body bolts. For additional information, refer to the Front End Body Panels Exploded View in FRONT END BODY PANELS .
Remove the RH fender reinforcement bracket.
- Detach the wire harness pin-type retainer.
Disconnect the washer pump electrical connector, washer fluid level sensor electrical connector and RH fog lamp electrical connector, if equipped.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

NOTE: To prevent spilling washer fluid, drain the washer reservoir before removal.

Disconnect the washer pump hoses.
Remove the 2 washer reservoir nuts and the washer reservoir bolt.
- To install, tighten to 9 Nm (80 lb-in).
Remove the washer reservoir from the vehicle.
NOTE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in premature washer pump failure.

To install, reverse the removal procedure.