Turn Signal/Hazard Lamps

The front turn signal lamps are located within the headlamp assemblies. The rear lamps share functionality with the stoplamps. When the multifunction switch is placed in the LH or RH TURN positions, the SJB  routes voltage to the LH or RH turn signal lamps. The SJB  then cycles the voltage on and off approximately 80 times per minute. If a front or rear turn bulb is inoperative, the SJB  cycles the voltage on and off approximately 160 times per minute.

The hazard switch is located on the instrument panel center moulding. When the hazard switch is pressed, the SJB  supplies voltage to all the turn lamps. The SJB  cycles the voltage on and off approximately 80 times per minute.