LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Parking Aid System >> Removal And Installation >> Parking Aid Module (PAM) >> Removal and Installation

Removal and Installation

    NOTE: Module configuration is required when a new Parking Aid Module (PAM) is being installed.
  1. Upload the PAM  configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
  2. Remove the RH rear interior quarter trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  3. Disconnect the Parking Aid Module (PAM) electrical connector.
  4. Remove the 2 nuts and the PAM  .
  5. To install, reverse the removal procedure.
    • Download the configuration information to the PAM  . For additional information, refer to Programmable Module Installation (PMI) in MODULE CONFIGURATION .
scientia non olet · About LEMON Manuals