Symptom Chart

SYMPTOM CHART

Condition	Possible Sources	Action
No communication with the Parking Aid Module (PAM)	Fuse Wiring, terminals or connectors PAM	REFER to MODULE COMMUNICATIONS NETWORK .
The parking aid is inoperative/does not operate correctly	Parking aid sensor alignment PAM Rear bumper cover	Go To PINPOINT TEST A .
Continuous or intermittent tone when no obstacles or fault codes are present (certain obstacles may not be detected or recognized due to their shape, size, or material)	Dirty or iced over parking aid sensor(s)	CLEAN the rear bumper and sensors with high-pressure water.
	Parking aid sensor bezel(s) or parking aid sensor(s) locked into the rear bumper incorrectly Parking aid sensors are not aligned correctly	REMOVE and correctly INSTALL the parking aid sensor(s) and or bezel(s) as necessary. REFER to PARKING AID SENSOR .
	Parking aid sensor(s) PAM	CARRY OUT the azimuth system check and elevation system check. REFER to AZIMUTH SYSTEM CHECK and ELEVATION SYSTEM CHECK .
The Audio output does not reduce when the parking aid tone sounds	Wiring, terminals or connectors PAM	Go To PINPOINT TEST E .