Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Coupe LH 50 percent backrest shown, RH similar.

All vehicles

Remove the rear seat cushion. For additional information, refer to Seat Cushion - Rear .

Coupe vehicles

Remove the bolt, pull the strap to pivot the backrest down, slide the backrest out of the backrest pivot bracket and remove the L/H backrest.
- To install, tighten to 23 Nm (17 lb-ft).

Vehicles with a convertible top

Remove the backrest bolts at the bottom, slide the backrest up, disengaging the hooks and remove the backrest.
- To install, tighten to 23 Nm (17 lb-ft).

All vehicles

To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.