LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.6 8, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Steering Column Switches) >> Removal And Installation >> Steering Column Multifunction Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

Turn signal/headlamp switch and windshield wiper/washer switch 

    NOTE: The instrument cluster finish panel is held in place with retaining clips that are attached to the bezel.
  1. Remove the instrument cluster finish panel.
  2. Remove the floor console finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE article.
  3. Remove the LH A-pillar lower trim panel.
  4. Remove the left center stack wing.
  5. Remove the 2 screws and the steering column opening cover.
    • Disconnect the headlamp and courtesy light switch electrical connectors.
  6. Remove the 4 bolts and the steering column opening cover reinforcement.
    • To install, tighten to 9 Nm (80 lb-in).
  7. Remove the upper steering column shroud by carefully pressing the sides inward.
  8. Remove the 3 lower steering column shroud screws and the shroud.

    9. Turn signal/headlamp switch 

  9. Disconnect the turn signal/headlamp switch electrical connector.
  10. Remove the 2 screws and the turn signal/headlamp switch.

    11. Windshield wiper/washer switch 

  11. Disconnect the windshield wiper/washer switch electrical connector.
  12. Remove the 2 screws and the windshield wiper/washer switch.

    13. Turn signal/headlamp switch and windshield wiper/washer switch 

  13. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals