LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.6 8, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Seat System - Seating) >> Removal And Installation >> Seat Control Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM & ORNAMENTATION article.
  2. Remove the seat control switch.
    • Separate the electrical connector and wire harness from the door panel.
    • Release the locking tabs in the door panel and remove the front seat control switch.
    3. Fig 1: Front Seat Control Switch Electrical Connector
    GF0013117Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals