Removal And Installation
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the electrical connector from the ignition coil.
- Disconnect the 6 spark plug wires from the ignition coil.
- Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
CAUTION:
It is important to twist the spark plug wire boots while pulling upward to avoid possible damage to the spark plug wires.
NOTE:
Spark plug wires must be connected to the correct ignition coil terminal.
NOTE:
Be sure to reinstall the radio ignition interference capacitor under the correct mounting bolt.