Removal And Installation
WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the LH trunk carpet trim.
- Disconnect the Inertia Fuel Shutoff (IFS) switch electrical connector.
- Remove the 2 bolts and the IFS switch.
- To install, tighten to 12 Nm (106 lb-in).
- To install, reverse the removal procedure.
NOTE:
Do not overtighten the fasteners or damage to the switch will occur.
NOTE:
If necessary, reset the IFS switch after installation has been completed.