LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.6 8, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (HVAC Climate Control System) >> Removal And Installation >> Heating Ventilation Air Conditioning (HVAC) Module >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.
  2. Detach the finish panel.
    3. Fig 1: Finish Panel
    GF0014383Courtesy of FORD MOTOR CO.
  3. Disconnect the electrical connector.
    4. Fig 2: Finish Panel Electrical Connector
    GF0014384Courtesy of FORD MOTOR CO.
  4. Remove the 4 heating ventilation air conditioning (HVAC) module screws.
    5. Fig 3: Climate Control Assembly Screws
    GF0014397Courtesy of FORD MOTOR CO.
  5. Remove the HVAC module.
    • Remove the nuts and disconnect the vacuum harness.
    • Disconnect the wire harness connectors and remove the HVAC module.
    6. Fig 4: Identifying Wire Harness Connectors
    GF0046791Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals