DTC Tables
INSTRUMENT CLUSTER (IC) DTC TABLE
| DTC | Description | Action |
|---|---|---|
| B1203 | Fuel Sender Circuit Short to Battery | Go to Pinpoint Test B . |
| B1204 | Fuel Sender Circuit Short to Ground | Go to Pinpoint Test B . |
| B1213 | Anti-Theft Number of Programmed Keys Is Below Minimum | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1255 | Air Temperature External Sensor Circuit Open | Go to Pinpoint Test AH . |
| B1257 | Air Temperature External Sensor Circuit Short to Ground | Go to Pinpoint Test AH . |
| B1317 | Battery Voltage High | CLEAR the DTCs. REPEAT the self-test. If DTC B1317 is still present, REFER to CHARGING SYSTEM - GENERAL INFORMATION article. |
| B1318 | Battery Voltage Low | Go to Pinpoint Test AB . |
| B1342 | ECU is Faulted | CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is still present, REPROGRAM the instrument cluster (IC). REFER to MODULE CONFIGURATION article. If the DTC is still present after the reprogramming, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| B1600 | PATS Ignition Key Transponder Signal Is Not Received | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1601 | PATS Received Incorrect Key-Code From Ignition Key Transponder | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1602 | PATS Received Invalid Format Of Key-Code From Ignition Key Transponder | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1605 | Lamp Anti-Theft Indicator Circuit Short To Battery | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1681 | PATS Transceiver Module Signal Is Not Received | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B1868 | Lamp Air Bag Warning Indicator Circuit Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B1868 is still present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| B1915 | Air Bag Driver Circuit Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B1915 is still present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| B2097 | Compass Module Failure | Go to Pinpoint Test AE . |
| B2103 | Antenna Not Connected | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B2141 | NVM Configuration Failure | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B2143 | NVM Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC B2143 is still present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| B2431 | Transponder Programming Failed | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| B2477 | Module Configuration Failure | CARRY OUT the instrument cluster (IC) programmable module installation (PMI). REFER to MODULE CONFIGURATION article. CLEAR the DTCs. REPEAT the self-test. If DTC B2477 is still present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . |
| U0140 | Lost Communication With Body Control Module (GEM) | Go to Pinpoint Test AC . |
| U0159 | Lost Communication With Parking Assist Control Module (PAM) | CLEAR the DTCs. REPEAT the self-test. If DTC B1318 is present, go to Pinpoint Test AB . If DTC U0159 is still present, REFER to MODULE COMMUNICATIONS NETWORK article to diagnose no communication with the driver seat module. |
| U0208 | Lost Communication With Seat Control Module (DSM) | CLEAR the DTCs. REPEAT the self-test. If DTC B1318 is present, go to Pinpoint Test AB . If DTC U0208 is still present, REFER to MODULE COMMUNICATIONS NETWORK article to diagnose no communication with the driver seat module. |
| U0244 | Lost Communication With Running Board Control Module (PRB) | CLEAR the DTCs. REPEAT the self-test. If DTC B1318 is present, go to Pinpoint Test AB . If DTC U0244 is still present, REFER to MODULE COMMUNICATIONS NETWORK article to diagnose no communication with the power running board module. |
| U1900 | CAN Communication Bus Fault - Receive Error | REPAIR all other DTCs first. CLEAR the DTCs. CYCLE the key off then on and wait 10 seconds. REPEAT the self-test. If DTC U1900 is still present, REFER to MODULE COMMUNICATIONS NETWORK article. |
| U2013 | Compass Module is Not Responding | Go to Pinpoint Test AE . |
| U2023 | Fault Received From External Node | U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs. |
| U2050 | No Application Present | REPROGRAM the instrument cluster (IC). REFER to MODULE CONFIGURATION
article. If the DTC occurs after the reprogramming, REPROGRAM the instrument cluster (IC) again. If the DTC is present after each attempt to reprogram, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| U2051 | One or More Calibration Files Missing/Corrupt | CARRY OUT the programmable module installation (PMI) for the instrument cluster (IC). REFER to MODULE CONFIGURATION
article. If the DTC is still present, INSTALL a new instrument cluster (IC). REFER to Instrument Cluster (IC) . TEST the system for normal operation. |
| U2510 | CAN - Invalid data for Vehicle Security | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
| U2511 | CAN - Data Mis-Match (Receive data does not match expected) | REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) article. |
SMART JUNCTION BOX (SJB) DTC TABLE
| DTC | Description | Action |
|---|---|---|
| C1769 | Park Brake Apply Switch Circuit Short to Ground | Go to Pinpoint Test I . |
| All other DTCs | - | REFER to MULTIFUNCTION ELECTRONIC MODULES article. |
PCM DTC TABLE
| DTC | Description | Action |
|---|---|---|
| P0457 | Evaporative Emission System Leak Detected (fuel cap loose/off) | Go to Pinpoint Test AA . |
| P0460 | Fuel Level Sensor A Circuit | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED article, go to Pinpoint Test B . |
| P0461 | Fuel Level Sensor A Circuit Range/Performance | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED article, go to Pinpoint Test B . |
| P0462 | Fuel Level Sensor A Circuit Low | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED article, go to Pinpoint Test B . |
| P0463 | Fuel Level Sensor A Circuit High | REFER to the Introduction - Gasoline Engines
article first. If sent here from the PC/ED article, go to Pinpoint Test B . |
| All other DTCs | - | REFER to the Introduction - Gasoline Engines article. |