Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.

CAUTION: Brake fluid is harmful to painted or plastic surfaces. If the brake fluid is spilled onto a painted or plastic surface, wash immediately with cold water.

Remove the brake pedal and bracket assembly. For additional information, refer to HYDRAULIC BRAKE ACTUATION article.
Remove the retaining clip from the clutch pedal pin.
Remove the 2 clutch master cylinder bolts, then disconnect the clutch master cylinder from the clutch pedal.
- To install, tighten to 10 Nm (89 lb-in).
Remove the reservoir hose from the clutch master cylinder.
To install, reverse the removal procedure.
- Install new hose clamps on the reservoir hose.
- Bleed the clutch hydraulic system. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION article.
- Refill the brake and clutch reservoir with the specified fluid.
- Check the clutch for normal operation.