LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.0 E, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Anti-Theft System - Passive Anti-Theft System (Pats)) >> Removal And Installation >> Passive Anti-Theft System (PATS) Transceiver >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition lock cylinder. For additional information, refer to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
  2. Disconnect the PATS transceiver electrical connector.
  3. Release the clips and remove the PATS transceiver.
    4. NOTE: Replacement of the PATS transceiver does not require the PATS keys to be programmed into the PCM again.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals