LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.0 E, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Charging System (Battery, Mounting And Cables)) >> Removal And Installation >> Battery Cables - 5.4L (4V) >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Disconnect the battery. For additional information, refer to Battery Disconnect .
  3. Position the positive battery terminal cover aside, remove the nut and position the generator harness terminal aside.
    • To install, tighten to 8 Nm (71 lb-in).
  4. Remove the locator from the dash panel.
  5. Remove the starter solenoid terminal cover.
  6. Remove the nut and position the starter solenoid positive cable terminal aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  7. Remove the nut and position the battery ground cable engine terminal aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  8. Remove the starter solenoid wire harness locator from the A/C compressor.
  9. Remove the battery cable harness locators from the body.
  10. Remove the battery cable harness locators from the oil pan.
  11. Remove the 2 battery cable harness locators from the RH strut tower.
  12. Remove the bolt and position the battery ground cable body terminal aside.
    • To install, tighten to 10 Nm (89 lb-in).
  13. Remove the battery cable harness locator from the battery tray.
  14. Remove the battery cable harness locator from the RH strut tower.
  15. Open the BEC cover, remove the bolt and position the BEC terminal aside.
    • To install, tighten to 10 Nm (89 lb-in).
  16. Remove the battery cables.
  17. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals