Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the affected seat. For additional information, refer to Seat - Front .
Disconnect the electrical connector.

Fig 1: Heated Seat Module Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the heated seat module.
- Insert a flat-blade screwdriver into the heated seat module bracket and release the locking tab.
- For installation, make sure the locking tab is correctly seated.

Fig 2: Heated Seat Module Locking Tab

Courtesy of FORD MOTOR CO.

To install, reverse the removal procedure.