LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 4.0 E, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Flexible Hose >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
    WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in FIRE SUPPRESSION SYSTEM article. Failure to follow the instructions may result in serious personal injury.
  1. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES article.
  2. Remove the brake caliper flow bolt and discard the 2 copper washers.
    • To install, tighten to 50 Nm (37 lb-ft).
    • Install new copper washers.
  3. Disconnect the brake tube fitting from the brake flexible hose.
    • To install, tighten to 15 Nm (11 lb-ft).
  4. Remove the bracket bolt and the brake flexible hose.
    • To install, tighten bolt to 17 Nm (13 lb-ft).
  5. To install, reverse the removal procedure.
    6. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM article. Failure to follow these instructions may result in serious personal injury.
  6. If equipped with fire suppression system, repower the system.
scientia non olet · About LEMON Manuals