Accessory Drive Belt Idler Pulley

Accessory Drive Belt Idler Pulley - 4.6L (3V)

Removal and Installation

1. Remove the air cleaner outlet pipe.

2. Rotate the accessory drive belt tensioner clockwise and remove the drive belt.





3. NOTE: The 4.6L (3V) has 3 idler pulleys, an upper RH, an upper LH and a lower LH.

Remove the bolt and the accessory drive belt idler pulley.

- To install, tighten to 25 Nm (18 lb-ft).

4. To install, reverse the removal procedure.
- For correct belt routing, refer to Accessory Drive Description and Operation, Accessory Drive Belt Routing, Front End Accessory Drive (FEAD) - 4.6L (3V) in the Description and Operation.