LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Explorer 2WD V8-4.6L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Camshaft, Lifters and Push Rods >> Lifter / Lash Adjuster >> Service and Repair >> Removal and Replacement >> Hydraulic Lash Adjuster

Hydraulic Lash Adjuster




Hydraulic Lash Adjuster





Removal and Installation

1. Remove the camshafts. For additional information, refer to Valve Train Components - Exploded View Valve Train Components - Exploded View, Camshaft - LH Camshaft - LH and Camshaft - RH Camshaft - RH.

2. Remove the remaining roller followers from the cylinder head being serviced.

3. NOTICE: If the components are to be reinstalled, they must be installed in their original positions. Mark the components for installation into their original locations. Failure to follow these instructions may result in engine damage.

Remove the hydraulic lash adjusters that are being serviced.

4. Inspect the hydraulic lash adjusters.

5. NOTE: Lubricate each of the hydraulic lash adjusters with clean engine oil prior to installation.

To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals