LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Expedition RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center - Instrumentation, Message Center, & Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Instrument Cluster (IC) >> IC Configuration

IC Configuration

The IC  contains items that are configurable. While some configurable items are customer preference programmable parameters configured through the scan tool, most items are configured at the end of the line production and only available for configuration through the PMI  procedure. Refer to MODULE CONFIGURATION .

NOTE: When installing a new IC  , it is necessary to upload the module configuration to the scan tool. Following installation of the IC  , download the module configuration from the scan tool into the new IC  . Refer to MODULE CONFIGURATION to carry out PMI  . It is also necessary to carry out a parameter reset procedure whenever a new IC  or PCM is installed. Refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .

IC Configuration Parameters 

PROGRAMMABLE PARAMETER CHART

Programmable Parameter PMI  Parameter
- Auto high beam control
- Autolamp delay timer
Autolock -
Auto-unlock -
- Compass
- Drive type (Four-Wheel Drive (4WD))
- Electronic Automatic Temperature Control (EATC)
- Flex-fuel vehicle
- Front parking aid
- Fuel tanks size
Gallon display type -
- IC  plant mode
- Integrated Keyhead Transmitter (IKT)
- Key-in-ignition chime
Language -
Metric display type -
- Number of fuel senders
Oil life warning threshold -
- Oil pressure gauge control
- Outside air temperature
Outside air units -
- Power liftgate
- Power running boards
- Rear air suspension (Vehicle Dynamics Module (VDM))
- Rear parking aid
- Transmission Control Module (TCM)
- Tire Pressure Monitoring System (TPMS)

IC Prove-Out 

The IC  and other vehicle modules carry out a display prove-out to verify that all module controlled warning/indicator lamps and monitored systems are functioning correctly within the IC  . When the ignition switch is cycled to the ON position with the engine off, the indicators illuminate to prove-out according the following table:

INDICATOR TYPE CHART

Indicator Indicator Type Prove-Out Duration
Air bag Warning 6 seconds
ABS Warning 3 seconds
Anti-theft indicator Indicator 3 seconds
Brake Warning 3 seconds
Malfunction Indicator Lamp (MIL) Warning Engine startup
Safety belt Warning 65 seconds if the safety belt is unbuckled, turns off when the safety belt is buckled
Speed control Indicator No prove-out
TPMS  Warning 3 seconds
High beam Indicator No prove-out
Overdrive (O/D) off Indicator No prove-out
RH/LH turn signals Indicator No prove-out