LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Expedition EL RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 69 (Anti-Theft System - Perimeter) >> Removal And Installation >> Door Disarm Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Disconnect the door disarm switch electrical connector.
  4. Separate the door disarm switch wiring harness retainer from the post on the LH door latch.
  5. Remove the E-clip.
  6. Remove the lock cylinder actuator pawl.
  7. Remove the door disarm switch.
  8. To install, reverse the removal procedure.
    • The door disarm switch mark must be positioned towards the harness side of the switch prior to installation.
    9. Fig 1: Identifying Door Disarm Switch Mark
    GF0001423Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals