LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Expedition EL RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 156 (Seat System - Seating) >> Removal And Installation >> Lumbar Control Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Driver side shown in illustration, passenger similar.
  1. Remove the lumbar control switch.
    • Release the tabs and remove the power lumbar bezel.
    • Disconnect the electrical connector.
    • Remove the lumbar control switch.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals