LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Expedition EL RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 152 (Instrument Panel & Console) >> Removal And Installation >> Console - Floor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2009 Mercury Grand Marquis and 2009 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console finish panel. For additional information, refer to Console Finish Panel - Floor .
  2. Remove the floor console storage bin and disconnect the power point electrical connector.
  3. Release and disconnect the electrical connector from the transmission selector lever assembly.
  4. Remove the 4 bolts and position the transmission range selector lever assembly aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  5. Remove the 2 floor console bolts.
    • To install, tighten to 8 Nm (71 lb-in).
    6. NOTE: Slide the floor console rearward to remove.
  6. Position the transmission selector lever assembly aside and remove the floor console.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals