LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Expedition EL RWD >> Repair and Diagnosis >> Brakes >> Parking Brake System - Parking Brake & Actuation >> General Procedures >> Parking Brake Cable - Rear, RH >> Removal and Installation

Removal and Installation

  1. Relieve the tension on the parking brake cable system. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
  3. Disconnect the RH rear cable from the cable union.
  4. Compress the 2 tabs and release the conduit from the equalizer.
  5. Disconnect the RH rear cable from the retaining clip.
  6. Remove the bolt and the wire form bracket from the LH side of the vehicle.
    • To install, tighten to 18 Nm (159 lb-in).
  7. Remove the rear parking brake cable-to-crossmember bolt.
    • To install, tighten to 18 Nm (159 lb-in).
  8. Remove the bolt and the wire form bracket from the RH side of the vehicle.
    • To install, tighten to 18 Nm (159 lb-in).
  9. Release the parking brake cable from the RH bracket assembly.
  10. Release the cable from the parking brake actuating lever and remove the cable.
  11. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals