Removal and Installation

Relieve the tension on the parking brake cable system. For additional information, refer to PARKING BRAKE CABLE TENSION RELEASE .
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
Separate the LH rear cable from the equalizer.
Compress the 2 tabs and remove the conduit from the bracket.

Fig 1: Removing Conduit From Bracket

Courtesy of FORD MOTOR CO.

NOTE: Be sure to correctly install the park brake cable retainer spring and route cables between suspension links.

Disconnect the parking brake cable retainer spring from the cable.
Disconnect the LH rear cable from the retaining clip.
Disconnect the ABS wheel speed sensor wire from the retaining clip.
Release the parking brake cable from the LH bracket assembly.
Release the cable from the parking brake actuating lever and remove the cable.
To install, reverse the removal procedure.