LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Escape Hybrid, AWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Cluster Illumination & Instrument Panel Illumination >> Diagnosis And Testing >> Instrument Cluster and Panel Illumination >> Pinpoint Tests >> Pinpoint Test F: The Individual Component Illumination is Inoperative >> Pinpoint Test F: The Individual Component Illumination Is Inoperative

Pinpoint Test F: The Individual Component Illumination Is Inoperative

NOTE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to BATTERY, MOUNTING AND CABLES .
  1. F1 CHECK THE VOLTAGE TO THE SINGLE ILLUMINATION SOURCE 
    • Ignition OFF.
    • Disconnect: Inoperative Illumination Source.
    • Place the headlamp switch to the PARKING LAMPS ON position.
    • Rotate the instrument panel dimmer switch to the full illumination position.
    • Measure the voltage between the inoperative illumination source, harness side and ground as follows:
      CONNECTOR PIN REFERENCE

      Component Connector-Pin Circuit
      Floor shifter C2096-3 VLN04 (VT/GY)
      Headlamp switch C205-2 VLN04 (VT/GY)
      Message center switch C269-1 VLN04 (VT/GY)
      Traction assist/parking aid disable switch C2114-6 VLN04 (VT/GY)
      Ambient lighting switch C3350-3 VLN04 (VT/GY)
    • Are the voltages greater than 10 volts? 
    • Yes:  TURN headlamps off. GO to F2  .
    • No:  REPAIR the circuit. TEST the system for normal operation.
  2. F2 CHECK THE GROUND CIRCUIT TO THE SINGLE ILLUMINATION SOURCE FOR AN OPEN 
    • Ignition OFF.
    • Disconnect: Negative Battery Cable.
    • Measure the resistance between the inoperative illumination source, harness side and ground according to the following table:
      CONNECTOR PIN REFERENCE

      Illumination Source Connector-Pin Circuit
      Floor shifter C2096-4 GD112 (BK/GN)
      Headlamp switch C205-1 GD112(BK/GN)
      Message center switch C269-4 GD112 (BK/GN)
      Traction assist/parking aid disable switch C2114-1 GD114 (BK/BU)
      Ambient lighting switch C3350-4 GD908 (BK)
    • Is the resistance less than 5 ohms? 
    • Yes:  INSTALL a new component in question. TEST the system for normal operation.
    • No:  REPAIR the ground circuit in question. TEST the system for normal operation.