LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Escape Hybrid, AWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Booster System - Power Brake Actuation >> Removal And Installation >> Brake Booster Vacuum Sensor - Hybrid >> Removal and Installation

Removal and Installation

  1. Disconnect the brake booster vacuum sensor electrical connector.
  2. Release the brake booster vacuum sensor retainer ring and remove the vacuum sensor.
    Fig 1: Releasing Brake Booster Vacuum Sensor Retainer Ring
    G06094485Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
  4. Following the scan tool instructions, carry out the multi-calibration routine.
scientia non olet · About LEMON Manuals