LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Escape Hybrid, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel & Console >> Removal And Installation >> Instrument Panel Finish Panel - Center, Upper >> Removal and Installation

Removal and Installation

  1. NOTE: The ignition switch must be in the OFF position if disconnecting the Passenger Air Bag Deactivation (PAD) indicator electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

    Turn the ignition OFF and wait at least 1 minute.

  2. Remove the upper instrument panel center finish panel.
    • Pull the upper instrument panel center finish panel outward.
    • Disconnect the electrical connector.
  3. To install, reverse the removal procedure.
    • Make sure to align the trim panel retaining clips to the retaining clip holes in the instrument panel.
scientia non olet · About LEMON Manuals