Instrument Cluster Finish Panel

Edge only 

1. Remove the upper instrument panel center finish panel.
   • Using a suitable tool, gently pry out the upper center finish panel to disengage the clips.
   • Remove the upper instrument panel center finish panel.
   • Disconnect the electrical connectors.

All vehicles 

2. Lower the steering column to the full down position.
3. Remove the steering column opening cover.
   • Remove the 2 steering column opening cover screws.
   • Disengage the steering column opening cover from the retainers.
   • Disconnect the electrical connector and tube, if equipped.
Fig 1: Locating Electrical Connector, Tube & Steering Column Opening Cover
Courtesy of FORD MOTOR CO.
4. Remove the 2 cluster finish panel screws.
Fig 2: Locating Cluster Finish Panel Screws
Courtesy of FORD MOTOR CO.
5. Disengage the instrument cluster finish panel from the retaining clips and remove the panel.
   • Disconnect the electrical connectors, if equipped.
6. To install, reverse the removal procedure.