LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Edge SE, FWD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Removal And Installation >> Side Impact Sensor - C-Pillar

Side Impact Sensor - C-Pillar

NOTE: RH shown in illustration, LH similar.
Fig 1: Exploded View Of Side Impact Sensor - C-Pillar With Torque Specification
GF0031280Courtesy of FORD MOTOR CO.
Item Part Number Description
1 W712191 Side impact sensor bolt
2 14B345 Side impact sensor
3 - Side impact sensor electrical connector (part of 14A005)
4 31012 Quarter trim panel
WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.
NOTE: The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
  1. Fold down the rear seat backrest.
  2. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
  3. Position aside the quarter trim panel.
    • Pull out on the quarter trim panel at the C-pillar to release the retaining clip to access the C-pillar side impact sensor.
  4. Fig 2: Pulling Out On Quarter Trim Panel At C-Pillar
    GF0031156Courtesy of FORD MOTOR CO.
  5. Disconnect the side impact sensor electrical connector.
  6. NOTE: Note the position of the 2 side impact sensor locating tabs for installation.
    NOTE: Make sure the C-pillar and side impact sensor mating surfaces are clean and free of foreign material.
  7. Remove the bolt and the side impact sensor.
    • To install, tighten to 11 Nm (8 lb-ft).
  8. WARNING: Always tighten the fasteners of the restraints control module (RCM) and impact sensor (if equipped) to the specified torque. Failure to do so may result in incorrect restraint system operation, which increases the risk of personal injury or death in a crash.
  9. To install, reverse the removal procedure.
  10. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .