Seat Cushion - Rear, 60 Percent

Seat Cushion - Rear, 60 Percent

1. Remove the 60 percent seat. For additional information, refer to Seat - Rear, 60 Percent Seat - Rear, 60 Percent.

2. If equipped, disconnect the 2 heater mat electrical connectors and separate from the backrest assembly.

3. Release the tab and remove the outboard cushion frame pivot bracket cover.

4. Release the tab and remove the inboard cushion frame pivot bracket cover.

5. Remove the 2 cushion frame pivot bracket bolts and the cushion assembly.
- To install, tighten to 25 Nm (18 lb-ft).

6. To install, reverse the removal procedure.