Seat Cushion - Rear, 40 Percent

Seat Cushion - Rear, 40 Percent

Removal and Installation

1. Remove the 40 percent seat. For additional information, refer to Seat - Rear, 40 Percent Seat - Rear, 40 Percent.

2. If equipped, disconnect the backrest heater mat electrical connector and separate the 2 heated seat electrical connectors from the backrest assembly.

3. Release the tab and remove the outboard cushion frame pivot bracket cover.

4. Release the tab and remove the inboard cushion frame pivot bracket cover.

5. Remove the 2 cushion frame pivot bracket bolts and the cushion assembly.
- To install, tighten to 25 Nm (18 lb-ft).

6. To install, reverse the removal procedure.