Antenna Cable - Satellite Radio, With Navigation

Antenna Cable - Satellite Radio, With Navigation

Removal and Installation

NOTE: The satellite radio antenna cable is part of the electrical harness. The cable is only serviceable by overlaying a new component and securing it to the electrical harness. Cut the ends off the existing cable and secure them with tape to prevent NVH concerns.

NOTE: A splitter is built-in to the front satellite radio antenna cable to split the satellite radio and Global Positioning System (GPS) signals. The splitter is only serviceable by cutting the existing splitter out and overlaying a new component on the wiring harness. Secure the new splitter to prevent NVH concerns.

1. Cut the ends from the existing component and tape them back.

2. Overlay the new component on the wiring harness and secure it as necessary.