Removal and Replacement

BUMPER COVER - REAR

Exploded View

Explorer:

Mountaineer:

Explorer Sport Trac:

Removal and Installation
1. Remove the tail lamp assemblies.
2. Remove the 2 rear bumper cover bracket bolts.
- To install, tighten to 11 Nm (8 lb-ft).

3. Remove the 9 bumper cover pin-type retainers.
4. Disconnect the rear parking aid sensor electrical connector, if equipped.

5. CAUTION: To avoid damaging the rear bumper cover, do not twist the cover when removing.

Remove the bumper cover.
- Lift the outer corners upward and pull the bumper cover straight up and out.

6. Transfer components as necessary.
7. To install, reverse the removal procedure.