LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Explorer 4.0 E, AWD >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the Explorer 4.0 E, 4WD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
All,Both Axles1.8B
Front,Both Sides1.0B
Rear,Both Sides1.0B
Combination Procedure: AXLE SEAL: Replace:
Semi-Floating Axle.
Rear,BothServiced with Wheel Hub Assembly.2.6B
Rear,One SideServiced with Wheel Hub Assembly.1.4B
Combination Procedure: BRAKE HOSE: Replace:
Includes: Bleed Brake System.
Each Additional0.2B
One0.4B
Combination Procedure: CALIPER: Overhaul:
One,Dual PistonIncludes: Bleed Brakes.0.7B
One,Single PistonIncludes: Bleed Brakes.0.5B
Combination Procedure: CALIPER: Replace:
OneIncludes: Bleed Brakes.0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Remove and Install for Refinishing:
NOTE: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation.
4WD, FrontNot Applicable.B
RearNot Applicable.B
Combination Procedure: DISC ROTOR: Replace:
4WD, Front,Each0.1B
Rear,Each0.1B
Combination Procedure: PARKING BRAKE SHOE & LINING: Replace:
Both Sides0.6B
Combination Procedure: WHEEL BEARING: Replace:
4WD, Front,One Side,Non Separable0.8B
Rear,BothServiced with Wheel Hub Assembly.0.8B
Rear,One SideServiced with Wheel Hub Assembly.0.5B
Combination Procedure: WHEEL HUB: Replace:
4WD, Front,One Side0.8B
Rear,Both0.8B
Rear,One Side0.5B