Wheel Knuckle: Removal

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

Remove the wheel bearing and wheel hub. For additional information, refer to Wheel Hub .
Remove and discard the tie-rod end nut.
Using the special tool, separate the tie-rod end from the wheel knuckle.

Fig 1: Separating Tie-Rod End From Wheel Knuckle

Courtesy of FORD MOTOR CO.

Remove the wheel speed sensor harness bracket bolt and position the harness aside.

Fig 2: Wheel Speed Sensor Harness Bracket Bolt

Courtesy of FORD MOTOR CO.

NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.

Remove and discard the stabilizer bar link lower nut.
Remove and discard the shock absorber lower nut and bolt.
Remove the 3 integrated wheel end bolts.
Remove and discard the upper ball joint nut.

NOTE: Be sure not to damage the ball joint boot when installing the special tool.

Using the special tool, separate the upper ball joint from the wheel knuckle.

Fig 3: Separating Upper Ball Joint From Wheel Knuckle

Courtesy of FORD MOTOR CO.

Remove and discard the lower ball joint nut.

CAUTION: Make sure to use the special tool when separating the lower ball joint from the knuckle to prevent damage to the ball joint boot.

Using the special tool, separate the lower ball joint from the wheel knuckle and remove the wheel knuckle.

Fig 4: Separating Lower Ball Joint From Wheel Knuckle

Courtesy of FORD MOTOR CO.

If necessary, remove the 3 brake disc shield bolts and remove the brake disc shield.