Transfer Case Shift Motor: Removal

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
Disconnect the harness connector.
Remove the coil wire pin from the electrical connector.
1. Remove the inner retainer from the wire connector.
2. Press the release tab and remove the coil wire pin.

Fig 1: Identifying Coil Wire Pin & Electrical Connector

Courtesy of FORD MOTOR CO.

Remove the transfer case shift motor bracket bolt and the 3 mounting bolts, then remove the transfer case shift motor.