Seat Position Sensor

NOTE: Power seat shown in illustration, manual similar.

Fig 1: Exploded View Of Seat Position Sensor

Courtesy of FORD MOTOR CO.

Item	Part Number	Description
1	-	Seat position sensor electrical connector (part of 14A699)
2	14B416	Seat position sensor
3	-	Seat position sensor retaining clip (part of 14B416)

NOTE: The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.

NOTE: The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

All seats

Power seats

Detach the wire harness routing pin-type retainer from the seat position sensor bracket.

Fig 2: Locating Wire Harness Routing Pin-Type Retainer From Seat Position Sensor Bracket

Courtesy of FORD MOTOR CO.

All seats

Fig 3: Pushing Apart Then Inward To Release Seat Position Sensor Locking Clip

Courtesy of FORD MOTOR CO.

Slide the seat position sensor rearward to release the 2 hooks from the bracket. Then remove the seat position sensor.
To install, reverse the removal procedure.
Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .