Passenger Air Bag Deactivation (PAD) Indicator
| Item | Part Number | Description |
|---|---|---|
| 1 | 13D730 | Passenger airbag deactivation (PAD) indicator |
| 2 | 04302 | Instrument panel (I/P) center finish panel |
| 3 | - | Passenger airbag deactivation indicator electrical connector (part of 14401) |
| Item | Part Number | Description |
|---|---|---|
| 1 | 04302 | Instrument panel center finish panel |
| 2 | 13D730 | Passenger air bag deactivation (PAD) indicator |
| 3 | - | PAD indicator electrical connector (part of 14401) |
| 4 | 7E391 | Console shifter bezel |
| 5 | 045A76 | Center finish console panel |
| 6 | W706092 | Instrument panel power point/storage bin retainers |
| 7 | 047A04 | Instrument panel power point/storage bin |
NOTE:
The air bag warning indicator illuminates when the correct restraints control module (RCM) fuse is removed and the ignition switch is ON.
NOTE:
The supplemental restraint system (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE:
The passenger air bag deactivation (PAD) indicator is part of the hazard switch/traction control switch assembly.
- Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .
- Remove the console shifter bezel (MKX only).
- Remove the center finish console panel (MKX only).
- Remove the 2 retainers from the power point/storage bin (MKX only).
- Pull and release the instrument panel center finish panel.
- Disconnect the PAD indicator electrical connector.
- Release the 4 tabs (2 upper and 2 lower) on the PAD indicator and remove it from the instrument panel center finish panel.
- To install, reverse the removal procedure.
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering .