B-Pillar Trim Panel
B-PILLAR TRIM PANELExploded View
Part 1:
Part 2:
Removal and Installation
1. Position the front seats in the full forward position.
2. NOTE: Inspect the safety belt D-ring cover for damage. If the safety belt D-ring cover does not remain in place, install a new cover.
Remove the safety belt D-ring cover and remove the safety belt bolt.
- To install, tighten to 54 Nm (40 lb-ft).
3. Remove the front door scuff plate trim panel.
4. Remove the rear door scuff plate trim panel.
5. Remove the lower B-pillar trim panel.
6. Position the front and rear door weatherstrips aside.
7. Remove the upper B-pillar trim panel assist handle, if equipped.
- Remove the bolt covers.
- Remove the bolts.
- To install, tighten to 9 Nm (80 lb-in).
8. Remove the B-pillar trim panel.
- Remove the screw cover.
- Remove the screw.
- To install, tighten to 9 Nm (80 lb-in).
9. To install, reverse the removal procedure.