Pinpoint Test A: The Clock Operation Is Erratic/Inoperative
- A1 CHECK CIRCUIT 483 (RD) FOR AN OPEN
- Key in OFF position.
- Disconnect: Clock C2016
Courtesy of FORD MOTOR CO.
- Measure the voltage between the clock C2016-6, circuit 483 (RD), harness side and ground.
- Is the voltage greater than 10 volts?
- YES
: Go to A2.
- NO
: VERIFY the SJB fuse 7 (7.5A) is OK. If OK, REPAIR the circuit. TEST the system for normal operation.
- A2 CHECK CIRCUIT 1205 (BK) FOR AN OPEN
Courtesy of FORD MOTOR CO.
- Measure the resistance between the clock C2016-3, circuit 1205 (BK), harness side and ground.
- Is the resistance less than 5 ohms?
- YES
: INSTALL a new clock. REFER to Clock in this article. TEST the system for normal operation.
- NO
: REPAIR the circuit. TEST the system for normal operation.