LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Freestar SEL >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Exterior Lighting System >> Diagnostic Tests >> Daytime Running Lamps (DRL) >> Inspection and Verification

Inspection and Verification

CAUTION: Make sure the engine is off during the entire procedure.
  1. Verify the customer concern by operating the daytime running lamps (DRL) following these steps:
    1. Place the headlamp switch in the OFF position.
    2. Place the front windshield wiper switch in the OFF position.
    3. Place the ignition switch in the RUN position.
      4. CAUTION: Make sure the vehicle is secure before carrying out this step.
    4. Shift the transmission out of PARK.
    5. If the DRL does not operate, make sure the smart junction box (SJB) is configured for DRL before proceeding to the next step.
  2. Verify the low beam operation.
    • Place the headlamp switch in the HEADLAMPS ON position.
    • Place the multifunction switch in the LOW BEAM position.

      If the low beams operate correctly and the DRL operation is incorrect, install a new SJB. Refer to MULTIFUNCTION ELECTRONIC MODULES article. Test the system for normal operation.

      If the low beams do not operate correctly, refer to Headlamps .

scientia non olet · About LEMON Manuals