LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Explorer 4.6 8, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Information Center >> General Procedures >> Compass Zone Adjustment >> Without Message Center

Without Message Center

  1. Turn the ignition switch to the ON position.
  2. Locate the reset button on top of the compass sensor located behind the mirror.
    3. Fig 1: Locating Compass Module Base Of Mirror
    GF0004497Courtesy of FORD MOTOR CO.
  3. Determine which magnetic zone you are in for your geographic location.
    4. Fig 2: Compass Calibration Zone Map
    G03965509Courtesy of FORD MOTOR CO.
  4. Press and hold the reset button on the compass module for approximately 4 seconds until COMPASS ZONE XX appears in the instrument cluster display.
  5. Continue to press the reset button until the correct zone setting for your geographic location appears in the instrument cluster display.
  6. After 4 seconds, ZONE SET appears in the instrument cluster display. The zone is updated.
scientia non olet · About LEMON Manuals