LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Edge SEL Plus, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (Engine - 6.0L (99P F450/550) Diesel -- F250-F550 Super Duty) >> In-Vehicle Repair >> Engine Front Cover >> Removal

Engine Front Cover: Removal

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the intake manifold. For additional information, refer to INTAKE MANIFOLD .
    2. NOTE: Remove the thermostat housing only if a new front cover is being installed.
  2. Remove the 2 bolts and the thermostat housing.
    • Remove and discard the O-ring seal.
      Fig 1: Locating O-Ring Seal
      G04648454Courtesy of FORD MOTOR CO.
  3. Disconnect the heater hose at the front cover.
    Fig 2: Identifying Clamp And Heater Hose
    G03921453Courtesy of FORD MOTOR CO.
  4. Disconnect the lower radiator hose.
    Fig 3: Locating Lower Radiator Hose
    G03921454Courtesy of FORD MOTOR CO.
  5. Remove the 3 bolts and position aside the power steering pump.
    Fig 4: Locating Power Steering Pump Bolts
    G04648457Courtesy of FORD MOTOR CO.
  6. Remove the bolts and the accessory drive belt tensioner.
    Fig 5: Identifying Accessory Drive Belt Tensioner Bolts
    G03887304Courtesy of FORD MOTOR CO.
    7. NOTE: Only one shown, others similar.
    NOTE: Remove the accessory drive idler pulleys only if a new front cover is being installed.
    Fig 6: Locating Accessory Drive Idler Pulley Bolt
    G03887524Courtesy of FORD MOTOR CO.
  7. Remove the bolts and the accessory drive idler pulleys.
    8. NOTE: Remove the coolant pump pulley only if a new front cover is being installed.
    Fig 7: Identifying Coolant Pump Pulley Bolts
    G04614086Courtesy of FORD MOTOR CO.
  8. Remove the 4 bolts and coolant pump pulley.
    9. NOTE: Remove the coolant pump only if a new front cover is being installed.
  9. Remove the 4 bolts and the coolant pump.
    • Remove and discard the O-ring seal.
      Fig 8: Locating Coolant Pump Bolts
      G03887306Courtesy of FORD MOTOR CO.
  10. Remove the nut and the battery cable bracket.
    Fig 9: Locating Battery Cable Bracket Nut
    G04648462Courtesy of FORD MOTOR CO.
  11. Remove the oil pump. For additional information, refer to OIL PUMP .
  12. Remove the bolts and the front cover.
    Fig 10: Identifying Front Cover Bolts
    G04648463Courtesy of FORD MOTOR CO.
    13. CAUTION: Sealant is used where the crankcase and lower crankcase meet. Failure to cut the sealant could result in pulling the lower crankcase seal out while removing the front cover gasket.
  13. Use a thin-blade scraper to cut the sealant where the crankcase and the lower crankcase meet. Remove and discard the front cover gasket.
    • Clean and inspect the sealing surfaces.
scientia non olet · About LEMON Manuals