LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Edge SEL Plus, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 441 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Ball Joint >> Removal

Ball Joint: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, 2006 Ford Cab & Chassis, and 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel spindle or wheel knuckle assembly. For additional information, refer to Wheel Knuckle .
  2. If equipped, remove the ball joint grease fitting.
    Fig 1: Locating Ball Joint Grease Fitting
    G04643103Courtesy of FORD MOTOR CO.
  3. Position the front wheel spindle in a vise and remove the snap ring from the lower ball joint.
    4. CAUTION: To avoid damage to the components, do not use heat to aid ball joint removal.
    Fig 2: Removing Lower Ball Joint
    G04643104Courtesy of FORD MOTOR CO.
  4. Using the special tools, remove the lower ball joint.
  5. Using the special tools, remove the upper ball joint.
    Fig 3: Removing Upper Ball Joint
    G04643105Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals